Tuckpointing in Mesquite TX - tight mortar joints that match your brick
Mortar crumbling or pulling away from your brick? We rake out worn joints by hand and refill them with a mix that suits your wall.
- Licensed and fully insured.
- Free estimates at your property.
- We reply within 1 business day.
Does your brick house need tuckpointing or just a few joints fixed?
Tuckpointing in Mesquite means raking out the worn mortar between your bricks and packing fresh mortar back into the joints, so the wall sheds water again and the bricks stay locked in place. It often comes with replacing a few cracked or loose bricks, and we usually work through a house one wall or section at a time.
Most calls start with the same question, whether the whole house needs it or just the worn spots. This is slow hand work and every joint takes time, so the price follows how much wall has bad joints, how high it sits and how easy it is to reach, and whether any bricks need brick repair before new mortar goes in. The schedule turns on those same things, plus whether the job needs a permit from the city. Your estimate gives you the figure for your own wall, with your options laid out in plain words.
How can you tell your brick needs tuckpointing?
Joints that crumble or sink
If you rub a joint and it turns to sand, or the mortar has sunk back from the brick face, it has worn past its working life. Left alone, every wet spell washes a little more out, and a small patch of repointing slowly turns into a whole wall.
Damp spots on inside walls
A water stain on drywall behind a brick wall can mean water is getting through bad joints, though it's worth ruling out the window and roof first. If the joints are the cause, that's the one to move on soonest, because water inside ruins drywall and trim long before the brick shows much.
Cracks through the brick
When a crack steps through the bricks themselves or keeps getting wider, that's usually more than worn mortar. Much of the ground in this part of Texas is Blackland Prairie clay that shrinks and swells a lot as it wets and dries, and structural cracks often need a proper look at the cause first, so I check that before anyone repoints over it.
Work that often goes with tuckpointing
Brick repair
When a brick has cracked, flaked or worked loose, we replace it with a close match before the joints around it get fresh mortar.
Driveway pavers
Once the brick on your house looks right again, a paver driveway in a tone that suits it can tie the whole front of the house together.
How we handle tuckpointing, one joint at a time
Our crew takes the old mortar out by hand on thin joints, so the brick edges stay crisp and the joints don't end up wider than they started. Then we mix new mortar to suit what's already on your house, close to the old in strength or a little softer, because a harder mix takes all the strain in that thin strip and can spall the brick, popping thin flakes off its face. I show you the mix before it goes on the wall, the same way a good cook lets you taste the sauce before it goes on the plate. We pack the joints, shape them to match the rest of the house, brush the brick clean and leave your yard as neat as we found it.
Worn joints often sit next to bricks that have cracked or come loose, and those get brick repair first so the new mortar has something solid to hold. While we're looking at the front of the house, some folks also ask about driveway pavers, and we're glad to look at both on the same visit.
Spot repointing
This suits a house where the wear sits in patches, like under a leaky gutter or along one side, because we only cut out the joints that have gone bad. It keeps the price down and leaves sound mortar alone.
Whole-wall repointing
This makes sense when most of the joints on a wall have worn back, since patching section after section leaves a spotty look. The whole face gets one mix and one joint shape, so it reads as one wall again.
Get a tuckpointing estimate for your brick walls
Send the form and we'll reply within one business day to set a time, then I'll come out for a free look at your joints with no obligation. Calling works too at (972) 402-6919.
Call (972) 402-6919Why Mesquite homeowners call Stonework Mesquite Concrete and Masonry for tuckpointing
The owner looks at your wall
I come out myself to look at your joints and answer your questions, and a crew of trained masons does the work while I check in on site. That way the person who priced your job is the one keeping an eye on it.
In business since 2013
We've been doing this work since 2013, and careful mortar and brick repair is what we're best known for. We're based in Mesquite and work in many of the cities around it, so if you don't see yours on the site, call and ask.
We check with the city first
If you're not sure whether your project needs a permit, we check with the city's Building Inspection Division before any work starts. That's the office that issues building permits for remodel work on Mesquite homes, so you get a straight answer from the people who decide.
Licensed and fully insured masons
We're licensed and fully insured, so you aren't the one carrying the risk while our crew works on your house. Every job is backed by our satisfaction guarantee.
On tuckpointing, the mix and the hand work count for more than speed, so tell us about your wall and let's set up a time to look at it.
What happens after you call about tuckpointing in Mesquite?
Call or send a message
Call (972) 402-6919 or use the form, and we'll get back to you to set a time that works. Tell us roughly where the worn joints are so I know what to look at first.
Walk the wall together
I come out myself, show you which joints are worn and which can wait, and explain why. You get your options and the price for each in plain words, so you can fix what needs it now and leave sound joints alone.
Permits, then the work
When you're ready, we take care of any city or county steps and line up inspections if the job needs them. Then a careful crew rakes out and repoints the joints while I check in on site.
Final walk-through before we leave
I walk the finished wall with you before we pack up, so you can see the joints up close. I'll also point out what to keep an eye on over the years.
Common questions
Is tuckpointing the same as repointing?
Usually, yes. Most people use tuckpointing to mean repointing, which is cutting out bad mortar joints between bricks and filling them with fresh mortar. The word also names an older finish, where joints are filled flush in a color close to the brick and a thin strip of contrasting mortar runs down the middle so each joint looks very thin.
How do I know if the mortar on my brick house needs repair?
Your mortar likely needs repointing if it has worn back more than about 1/4 inch from the brick face, crumbles, has holes, shows hairline cracks or has split away from the brick. That's the list an older brick industry guide uses, and the same guide says sound original joints beat repointed ones, so a good job cuts out only the bad joints.
Do cracks in mortar joints need to be fixed right away?
Not always. Brick industry maintenance guidance says minor cracks don't call for immediate repair, because brick veneer and cavity walls, the kinds built with a gap behind the brick, handle a little extra moisture. It ties repair to cracks that line up with water leaking inside once other causes are ruled out, so watching first is reasonable, and I'll tell you honestly if yours can wait.
How much does tuckpointing cost in Mesquite, TX?
Professional brick repointing across the US usually costs about $400 to $2,500 per 100 square feet of wall. That's a national range for the work, not our price. The way to know your number is to have me measure the worn area at your house and price it at the estimate.
How long does tuckpointing last?
Mortar joints typically last more than 25 years, while the bricks around them may well last more than 100. That makes repointing normal upkeep over a brick home's life, and how soon yours comes due depends on how exposed the wall is and what mortar was used.
Who can get a building permit in Mesquite?
In Mesquite, only licensed contractors, or homeowners who own, live in and homestead the home through the Dallas Central Appraisal District, can get a building permit. If you have questions about codes, inspections or which permits your project needs, the city's building inspection office answers them at 972-216-6212.
Get your worn brick joints looked at
Call (972) 402-6919 or use the form, and have a few photos of the worn joints, a rough idea of the wall area and any inside leaks noted, so the visit goes straight to what matters.