Stonework Mesquite Concrete and MasonryStonework Mesquite Concrete and Masonry

Walkway construction in Mesquite TX - a path built to stay level and tight underfoot

Worn shortcut across the lawn or a cracked walk by the door? We build a concrete or paver path that sits flat.

A broad paver walkway beneath a raised deck, made of gray and tan rectangular stones with a dark border.
  • Licensed and fully insured.
  • Free estimates at your property.
  • We reply within 1 business day.

What does building a new walkway involve, from the dig to the final edge?

Walkway construction in Mesquite means building a new path to your door, patio or gate from poured concrete or from pavers, which are separate pieces laid one by one. Done right, it gives you a level, dry way across the yard, and it often goes hand in hand with a low wall, steps or a stone border.

Most people who call about a walk want a dry, level way to the front door, or a path out to the patio or side gate that the old one never gave them. The price mostly turns on how long and wide the path is, whether it's concrete or pavers, how much old walk or sod has to come out, and how many curves or steps it takes. The schedule turns on the material, because a poured walk goes in faster than pavers set one piece at a time, and on whether the city wants a permit, which we check before any work starts. At the estimate I walk the route with you and lay out your choices in plain words.

How do you know it's time for a new walkway?

  • A trail worn through grass

    You see a bare strip where everyone cuts across the yard, which usually means the way in isn't where people actually walk. Left alone, it turns to mud every time it rains, and that mud ends up on your floors.

  • Stepping stones sinking or rocking

    The stones tip when you step on them or sit lower than the grass, which usually means nothing firm was packed underneath. Waiting lets the edges rise unevenly until one catches a toe.

  • Cracked walk that trips people

    One section sits higher than the next or the slab has broken into pieces, which usually means the old walk has moved past the point of patching. The longer it goes, the more it breaks up and the more likely someone falls.

  • Brick wall installation

    A low brick wall beside the path can hold back a planting bed or frame the front yard, giving the walk a finished edge on one side.

  • Stone masonry

    Natural stone steps, borders or a seat wall can tie a new walkway to the house when you want it to match stone already on the property.

How our crew handles walkway construction

It starts at the estimate, where I help you choose between poured concrete and pavers based on how you use the path and how long you're happy having a crew around. Then we mark the layout, dig out the old walk or sod and pack the ground underneath, because a walk is a lot like a dish in a kitchen, and the prep nobody sees decides how it turns out. For concrete, we set forms, pour, finish the surface and leave it to cure. For pavers, we compact the base well, lay the pieces and set a solid edge along the sides so the path stays tight. We pick a color and finish that suit your house, and we clean up as we go, a habit I brought with me from restaurant kitchens.

If a low wall along the path makes sense, we plan the brick wall installation with the walk so the two line up and share one dig. Natural stone steps or a border are part of our stone masonry work, and laying them out with the walk keeps the heights and edges matched.

  • Poured concrete walk

    This suits you if you want a plain, smooth path and less time with a crew in your yard, since the whole walk goes in as one pour. It works well for straight runs to the door and paths that get daily use.

  • Paver walk

    This suits you if you want color, pattern or curves, and you don't mind a longer job while the pieces go down one at a time. A paver can be lifted and reset later if one section ever needs work.

Get a free estimate for your new walkway

Send the form and we reply within 1 business day to set a time for me to come out. The estimate is free, at your property and obligation-free, and a call works too.

Call (972) 402-6919

Why Mesquite homeowners call Stonework Mesquite Concrete and Masonry for walkways

  • I walk every estimate myself

    I come out, answer your questions and put the estimate together, then a crew of trained masons does the work while I check in on site. The person who heard what you wanted is the one making sure it gets built that way.

  • Licensed and fully insured

    We're licensed and fully insured, so you aren't carrying the risk if something goes wrong while our crew is in your yard. It's a fair thing to ask any contractor you're comparing.

  • In business since 2013

    We've been doing masonry for 13 years, and I still run a job site the way I ran a kitchen line, cleaning as we go. That means you're not stepping around dirt piles and scraps for the length of the job.

  • Based in Mesquite, nearby cities too

    We're based in Mesquite and work in many of the cities around it, including Garland, Rowlett and Forney. If you don't see your city on the site, call and ask.

On a walkway, the ground under it matters most, so that's what I'll look at hardest when I come out. Contact us or call (972) 402-6919 to set up a visit.

What happens when you call us about a walkway in Mesquite?

  1. Call or send a message

    Call (972) 402-6919 or use the form, and we'll get back to you to set a time that suits you. It helps to tell us roughly where the path runs and what it connects.

  2. I come out and look

    I come out myself, walk the route with you and point out what I see, from where water sits to how the old walk has moved. You get an estimate with your concrete and paver options laid out plainly, so you can weigh the cost against how long you want a crew around.

  3. We handle permits and build

    When the walk needs a permit, we take care of the application and line up the inspections, and since the city wants permitted work left open and visible until its inspectors approve it, we hold that stage until it passes. A careful crew of trained masons does the work, and I check in on site.

  4. Walk the finished path together

    Before we pack up, I walk the finished job with you and show you what to keep an eye on later. On new concrete, that includes keeping foot traffic off while it cures.

Common questions

  • What does a concrete walkway cost around Mesquite?

    Installing a concrete walkway in the Dallas area usually costs about $8 to $25 per square foot. That's the going rate around the area, not a quote from us, and where yours lands depends on the path's size, how much has to be dug out, the finish and how many curves or steps it has. Your estimate gives you your own figure.

  • What is the best way to choose between concrete and pavers for a walkway?

    Choose concrete if you'd rather have less time with a crew on site, and pavers if you like the look of separate pieces and don't mind a longer job, since concrete pours without anyone laying and grouting pieces one by one. With pavers, the paver industry's trade group says firmly packing the soil underneath keeps settling to a minimum, and it calls flat metal or plastic garden edging unacceptable as a border and warns against timber because it warps and rots. Ask any installer what edge they plan to use, and I'll show you ours at the estimate.

  • How long does new concrete take before you can walk on it?

    Michigan concrete trade guidance says a new walk can open to traffic after 7 days of curing, or sooner when testing confirms its strength. That comes from another state's trade group, but it's a sensible way to plan, so keep regular foot traffic off the path for that curing time.

  • Should I seal a new concrete walkway?

    You can, and Michigan concrete trade guidance says a penetrating sealer can go on 30 days after the concrete is placed. It typically needs reapplying every three to five years, so think of sealing as regular upkeep rather than a one-time job.

  • Who can get a building permit in Mesquite?

    Under Mesquite's permit process, the city issues permits through Citizen Self Service to licensed contractors or to homeowners who qualify. A homeowner qualifies by owning, living in and homesteading the home through the Dallas Central Appraisal District, and anyone else needs a professional license with the city before getting a permit. When your walkway needs one, we take care of the application and line up the inspections.

  • Who do I call about a walkway permit in Mesquite?

    Call the city's Building Inspection Division at 972-216-6212 for questions about codes, inspections and which permits your project needs. For setback or zoning questions, such as how close a path can run to the property line, the Planning Department answers at 972-216-6216. If you'd rather not make the call, we'll check with the city before any work starts.

Get a price on your new walkway

Call (972) 402-6919 or use the form with the path's rough size in square feet and your pick of concrete or pavers, since walkway prices usually run by the square foot.

(972) 402-6919Request a quote